GOLDEN Crackle Paste Golden

GOLDEN Crackle Paste is a thick, opaque cracking material, designed to develop deep fissure-like cracks as it cures. The size and extent of the crackle pattern is dependent on many factors, including the thickness of application, and the environmental conditions (temperature, relative humidity and air flow) during drying. The cracking performance is, to some extent, unpredictable. 

Crackle Paste is a water-based product formulated with styrene-acrylic copolymer emulsions, and may have a tendency to yellow.

Further Information

This product has white, low-density solids that replace traditional fillers. Its unique ratio of specific solids and binders allows for a “controlled failure” to occur and the result is its tendency to crack. It has a consistency similar to cake icing, easily manipulated by a palette knife. Peaks will maintain their height and appearance. It is a harder film than the GOLDEN Light Molding Paste, yet still retains an absorbent surface.

Films dry to an opaque, matte finish to which subsequent layers of acrylic paint and mediums can be applied. Crackle Paste can be easily tinted with GOLDEN Heavy Body, Matte, High Load and Fluid Acrylic Paints.

This is a highly variable product, and it should NOT be assumed that it will perform exactly the same each time the product is used. Review this information carefully and conduct testing before using this product on artwork or decorative finishes.

Drying times greatly depend upon film thickness. Very thin films will dry to the touch in several hours but may not develop much cracking. Increasing film thickness will increase the tendency to crack and also the size of the cracks and platelets. Cracks can take several days to fully develop.

Do not force dry Crackle Paste, nor try to slow the drying by adding Retarder or other additives, as both conditions may interfere with the products ability to crack. 

Crackle Paste cleans up with soap and water. Do not let products dry on tools. Keep tools wet while in use. Soak tools in soapy water to remove dried films.

While it is possible to apply Crackle Paste onto a wide variety of surfaces, the extreme shrinking can warp flexible products like paper or canvas. Therefore, applications onto rigid supports such as wooden panels, sheetrock (decorative/faux finish applications) or hardboard are recommended.

Product Information Sheet